the middle where it screws together had a plastic bearing like thing around it its like at a slant l think a grip would work not sure

sorry you dont you go to wal mart and buy a new one

Call Harendra.

91-9979288816

You need to make friends with the guy you hit with it so thaty you can reshape it again using his head.

Well depending on what kind of cue it is u might be able to have it fixed, or call the cue company if it was by natural causes because that should not happen. To see if u just need a new shaft take it off & roll the butt end on a flat surface like a pool table & if the joint pin (screw part) does not wobble while rolling it u know its the shaft. If it does u will need to look into a new cue or maybe its under warranty. l would also say if u r serious about pool & have the means, do not buy a cue at wal mart. You get what u pay for, & that would be junk. Good luck & keep rackn em up!

Take it to a pro to see if it can be fixed..once it is bent though the best thing to do is buy a new cue.buy a decent one and it should not bend. You need to buy a good quality cue.

l am not real sure what you mean. If your talking about one of the sleeves at the joint it can probably be replaced pretty easily by a good repairman. If you mean a warped shaft just throw it away or use it for firewood. Go to a cue maker or your cues manufacturer and have a new one made.It is a lot cheaper than buying a whole new cue. That is provided you have a decent cue and not a wally world special.

''Chalk'' it up to experience and just get a new one!